Clear Coat For Maple Wood

The main difference is that a clear coat does not alter the color of the wood while a stain does.

Clear coat for maple wood.

Applying a clear finish to wood brings out the wood s natural beauty while sealing and protecting the wood s surface. Another commonly used finishing technique on maple is to apply tung oil or linseed oil after the final sanding. If desired these two options can be combined for a mix of beauty and durability. A good finish whether a clear coat or a stain gives you a chance to lock out moisture and remove the risk of rot mold or mildew.

Always apply a second coat and you may want to repeat the process with a third coat. Stir the polyurethane clear coat with a stir stick. Allow to dry for 2 hours allowing for shrinkage and tightening of the films to take place. Start by sanding the surface thoroughly and wiping it down to remove any dust.

Apply a coat of finish and then tone the wood by spraying pigment on the dried finish or wiping on a gel stain. Fruitwood snw stain on hard maple wood. Coating wood cabinetry furniture or trim with a clear finish whether you stain it or not gives it richness and depth while protecting it from knocks scrapes and the weather. Most projects will be ready for normal use in 24 hours.

These oils tend to bring out the curly or tiger looks of the maple. Fine sand the 2nd coat with 400 grit to remove surface defect and apply one more coat. For a more durable finish top coat over the shellac with a clear lacquer or polyurethane. Most clear finishes are applied with a brush working in the direction of the grain of the wood.

Natural clear coat no stain on soft maple wood. For added durability a third coat can be applied. Even when you seal the maple and apply a stain the color may be more uneven than you d prefer and there s an easy way to remedy that. Use this guide to learn more about choosing and using polyurethane the toughest of the clear coatings.

When applying polyurethane finish allow the first coat to dry overnight then sand it lightly with 220 grit sandpaper. Open the can of clear coat and use a stir stick to mix it up. Keep stirring the clear coat until it s thoroughly mixed. Our natural no stain is a clear coat that allows all the natural color grain and character of the wood to show through.

The 3 coats will melt into one another and will form a hard clear shell within 24. Most floors require two to three coats of polyurethane for adequate protection. Be sure not to shake the can since it could form bubbles and ruin how the clear coat applies to your piece of maple. Related products options.

Then remove all the sanding dust and apply a second coat. Allow each coat to dry for 20 40 minutes at 1 3 mils wet film thickness per coat.